e2900

I have recently racked an e2900 after a year or so delay. The problem is that there is no power being fed to the system. Not even the auxillary bus is powering up to get fan 3 going.

I seem to recall when I first set up this system that I had to use the right power cords to get the system powered on in the first place. Of course in the past year the power cords are long lost.

Am I dealing with a false memory here about the power cords. Has anyone else run into this issue.

[496 byte] By [ralph@cancerboard.ab.caa] at [2007-11-27 6:29:56]