Ultra 60 ttya issue

I have an ultra 60, and I have no issues accessing console, via ttya, with Tera Term.I can access obp, and type commands with no problem.

When I hook up ttya to a RJ access server (terminal server), I can see the banner message. Once server hits OK prompt, I can not type any characters. If I take the same RJ access line, and hook to an ultra 5, or 10 it works fine.

I do have the U60 motherboard jumpers set to rs-232. Problem exists with either setting.

I am not sure that the issue is at the server level. It may well be at the terminal server. However,I can not connect by moving any good line to this server, yet I can take this line to other servers and it works fine.

Any suggestions would be appreciated.

[745 byte] By [cdbmoca] at [2007-11-27 5:03:22]