Primary LDom configs
I set up our primary domain following the example in the beginner's guide to the letter. I saved the configureation "initial" just like it said.
I powered the system completly to add in fiber cards and when I brought the system back up, the primary domain booted into the "factory default" config.
I used ldm to set the system to use the "initial" config again and rebooted. Most everything came back correctly, except the setup the of the disk assignments to the disk server in the primary domain, these were called vol1 and vol2.Everything is back to normal now, including the moving of the second pci branch to my service domain. I have created another config, saved it and rebooted to make sure everything stays the same on a reboot.
Did I miss a step in saving which config to use when the system is completely powered off? Or is this some form of bug?
Kevin
