ultra 10 hard rive question

Hi there,I have an ultra 10 and I had to change the hard drive. Is there some way to tell if the system sees the new drive? Do I have tell it somehow that it has a new drive or will it just see it when it boots?Thanks

[238 byte] By [r0k3ta] at [2007-11-26 12:58:39]

«« Need Solaris "CD0" - willing to pay $
»» Runtime.getRuntime().exec

# 1

Hello,

I had to change the hard drive. Is there some way to tell if the system sees the new drive?

Yes, probe-ide at the ok-prompt should list the detected drives (hd, cd-rom).

This is a sample

ok probe-ide

Device 0 ( Primary Master )

ATA Model: ST38420A

Device 1 ( Primary Slave )

Not Present

Device 2 ( Secondary Master )

Removable ATAPI Model: CRD-8483B

Device 3 ( Secondary Slave )

Not Present

If it's an additional drive boot with boot -r.

Michael

MAALATFTa at 2007-7-7 16:56:31 >

top of Java-index,Sun Hardware,Workstations - General Discussion...

# 2

Hi there, Yes, thank you... I replaced that hard drive and it solved the problem. It was showing up on the PC just not on the ultra so I figured it was some config issue but that wasn't the case I put in another drive and it was fine. Thanksken

r0k3ta at 2007-7-7 16:56:31 >

Java programming resources: FAQs, tutorials, compiler and browser download sites, documentation, books lists, IDEs, etc.

ultra 10 hard rive question

Sun Hardware New Topic

Sun Hardware Hot Topic

Sun Hardware

All Classified