T3+ cyclic reboot
Hello
I have certain T3+ array that cannot boot correctly, instead constantly rebooting in cycle
In terminal I have the following
...
T3B-EP Release 2.00 2001/06/22 16:07:00 (192.168.11.163)
Copyright (C) 1997-2001 Sun Microsystems, Inc.
All Rights Reserved.
Found units: [u1-ctr]
auto boot is enabled
hit the RETURN key within 3 seconds to cancel...
Starting...
T3B Release 2.00 2001/07/12 19:35:12 (192.168.11.163)
Copyright (C) 1997-2001 Sun Microsystems, Inc.
All Rights Reserved.
Initializing software...
Found units: [u1-ctr]
Default master is u1
Starting Heartbeats...
Assigning Select IDs: u1(1)
Initializing system drivers...
Initializing XPT component...
Initializing QLCF component...
Initializing loop 1 ISP2200 ... firmware status = 3
Detected 10 FC-AL ports on loop 1
Initializing loop 2 ISP2200 ... firmware status = 3
Detected 10 FC-AL ports on loop 2
Initializing SVD services...
Detected data cache size in system: 1GB
Open Disk Failed, LID = 9
Testing ISP2200... Passed
Testing ECC mechanism... Passed
Testing XOR functions and datapaths... Passed
Cold Boot detected; destructive tests OK...
Testing data cache memory... Passed
Initializing Cache Memory...
Open Disk Failed, LID = 9
Erasing Flash...done
Programming Flash...........................................ERROR : file checksum error !!
EPROM updated, restarting...
T3B-2
Starting POST
.........
POST end
Starting...
T3B-EP Release 2.00 2001/06/22 16:07:00 (192.168.11.163)
Copyright (C) 1997-2001 Sun Microsystems, Inc.
All Rights Reserved.
Found units: [u1-ctr]
auto boot is enabled
hit the RETURN key within 3 seconds to cancel...
Starting...
T3B Release 2.00 2001/07/12 19:35:12 (192.168.11.163)
Copyright (C) 1997-2001 Sun Microsystems, Inc.
All Rights Reserved.
Initializing software...
Found units: [u1-ctr]
Default master is u1
Starting Heartbeats...
Assigning Select IDs: u1(1)
Initializing system drivers...
Initializing XPT component...
Initializing QLCF component...
Initializing loop 1 ISP2200 ... firmware status = 3
Detected 10 FC-AL ports on loop 1
Initializing loop 2 ISP2200 ... firmware status = 3
Detected 10 FC-AL ports on loop 2
Initializing SVD services...
Detected data cache size in system: 1GB
Open Disk Failed, LID = 9
Testing ISP2200... Passed
Testing ECC mechanism... Passed
Testing XOR functions and datapaths... Passed
Cold Boot detected; destructive tests OK...
Testing data cache memory... Passed
Initializing Cache Memory...
Open Disk Failed, LID = 9
Erasing Flash...done
Programming Flash...........................................ERROR : file checksum error !!
EPROM updated, restarting...
T3B-2
....
It reboots again and again: trying to update flash, failing and rebooting.
Could anyone help me to stop this cyclic reboot? All I need now is to get the telnet/ftp to this array and update firmware to latest 3.2.x...
Does anybody have any suggestions?
