ras_admin tool does not discover my 6130
I have recently acquired several 6130 units. I am having problems discovering these units after I installed "SUNWstade". I connected the 6130 directly to the management host using crossover ethernet cables as defined in the documentation. Even though I have connected both ports directly to the management host, only 1 of the 2 default addresses responds to a ping.
I have been unable to get the web interface to work either, so I instead tried using the "ras_admin" tool.Here is the syntax and results:
{camel}/opt/SUNWstade/bin> ./ras_admin discover_deviceIP
Reading deviceIP: 192.168.128.1016130_1 6130# test setup
Start Discover::fromIP on 192.168.128.101
- No Device found for 192.168.128.101 using 6130 type, please check for a valid ip/type.
- Valid types are 5210 samfs inrange 9900 5310 5310C switch switch2 qlogicsw brocade 6130 mcdata 3310 3320 3510 3511 t3 6020 6120 se se2
->No device detected
Reading deviceIP: 192.168.128.1026130_2 6130# test setup
Start Discover::fromIP on 192.168.128.102
- No Device found for 192.168.128.102 using 6130 type, please check for a valid ip/type.
- Valid types are 5210 samfs inrange 9900 5310 5310C switch switch2 qlogicsw brocade 6130 mcdata 3310 3320 3510 3511 t3 6020 6120 se se2
->No device detected
Adding devices from deviceIP.local to configuration:
Any advice or tips you can offer which would help me to both discover the 6130, and/or properly configure the Web based management software would be greatly appreciated.
Phillip Pacheco
Genesys
