Changing the managment IP on T3 and T4 arrays

Hello all, hope this is the right forum!

I've changed the managment IP's on two arrays, a t3 and t4, using the commands "set ip A.B.C.D" and see that the new configuration reflects the change by issueing the command "set ip". Neither of the array's are accessable via the new IP, however they still respond to the original IP just fine.

Is there a way to flush the IP configuration out of these without rebooting?

[435 byte] By [wilschultz] at [2007-11-26 7:07:31]