LOM Port getting garbage

Hello,

please review these two sticky posts

<a href="http&#58;&#47;&#47;supportforum.sun.com/hardware/index.php?t= msg&amp;th=5291&amp;start=0&amp;rid=23&amp;SQ=66e7d57767f623b9b4 de565d393b1a32" target="_blank"><b>sticky: Attaching a PC to Sun workstation/server</b></a>

<a href="http&#58;&#47;&#47;supportforum.sun.com/hardware/index.php?t= msg&amp;th=3542&amp;start=0&amp;rid=23&amp;SQ=66e7d57767f623b9b4 de565d393b1a32" target="_blank"><b>sticky: How to connect to Sun Systems via TIP</b></a>

Is your cable known as good (= correctly wired) ?

Are the communication settings correct (9600,8-bit,no parity,1 stop bit) ?

Michael

maal at 2007-7-5 14:08:23 >

Hello Deepak,

the LOM port of the V100 is <u>serial</u> A (RJ45).

<i>How to connect via LPT (DB25)connector </i>

It's impossible to connect via LPT (<u>parallel</u>) port.

<i>db9 conecttor cable fine bcoz it's working fine another v100</i>

Use the same setup: Cable attached to the V100 serial A and the serial port of your Windows system.

Did you read the documents from the two sticky posts or at least the <b>Sun Fire V100 Server User s Guide</b> (Part-No. 816-2756-10, CHAPTER 3: Communicating With the Server, page 19ff)?

If you're unable to solve the problem with the help/suggestions from a User-To-User forum, open a service case with Sun or ask a senior admin at your site.

Michael

maal at 2007-7-5 14:08:23 >