Re-enabling the "terminal emulation" on a StorEdge 3511?

I was poking around for serial parameters to tweak to improve the serial communications between our Linux+Cyclades serial terminal concentrator to a StorEdge 3511 RAID controller, and mistakenly tried "Turn off terminal emulation".

I seem to be doing fine setting up the RAID array using sccli now, but even since I turned that off, the serial port hasn't worked at all.

Is there a way, using sccli, to turn that terminal emulation back on?

Thanks!

[481 byte] By [strombrg] at [2007-11-25 23:17:17]

«« 3511's and serial communication?
»» Big LUN's?

# 1

You should be able to use the network interface to telnet into the box if you've set the ip addresses etc.Failing that, I'm afraid it's probably a NVRAM reset that's required.Good luck,--A.

andrewness at 2007-7-5 18:05:56 >

Storage General Discussion

Java programming resources: FAQs, tutorials, compiler and browser download sites, documentation, books lists, IDEs, etc.

Re-enabling the "terminal emulation" on a StorEdge 3511?

Storage Forums New Topic

Storage Forums Hot Topic

Storage Forums

All Classified