Driver problem?
Ok, I齧 having this problem and I齧 not sure what it is. I齰e connected a L25 to a V1280 and when I probe-scsi-all, I can see it. BUT after doing a boot 齬, the device doesn齮 show up in /devices. I also did devfsadm & drvconfig/tapes to no avail. Below it what I have as output from the above.
<ok> probe-scsi-all
/ssm@0,0/pci@19,700000/pci@1/scsi@5
Target 0
Unit 0 Removable Medium Changer M4 DATA Magfile 3.06
Target 1
Unit 0 Removable Tape HP Ultrium 1-SCSI E31F
<ok> boot 齬
When I loaded the Solstice backup software, I saw the following:
Legato SCSI pass through driver configured and loaded
Legato optical driver configured ?will be loaded at next boot
I rebooted but still not tape device.
I齧 not sure if I齧 missing a driver for the changer/robot or what.
Thanks,
Bert
PS. This is my hardware
V1280 --> PCI dual channel Ultra-3 differential SCSI host adapter --> L25 (LTO LVD base unit
The drive is LTO gen 1 LVD SCSI drive
The SCSI cable is 4-meter 68pin to VHDC differential Ultra SCSI cable.
