I was recently gifted a used 3510. When it powers on, I'm getting the beep code for SES/PLD firmware mismatch.
However, when I get into the controller and do a show ses-devices, it doesn't list any, so that makes it a little impossible to upgrade the firmware.
Anyone have any thoughts?
What do you get when you do a show inq and show red?
Also what version of sscli are you using?
If you can find the active controller, pull out the other one and then reset the system.Hopefully the mismatch will disappear with one controlller.
Then do a show ses and see what happens. Depending on the version (say 3.27R), you may see the the 1000 and 1040 (I think).
If that works, shove the other controller back in and then have a play with it.
HTH!
Stephen
