Bad serial connection?

We have a 3510 array here that we are configuring via the serial port at the back of the system.

The 3510 was a dual raid base and it worked fine. Now it is going to be used as a single raid with a JBOD card. The issue is when we fire it up and have a look through the serial connection instead of getting the nice little option screen to configure it we get a screen of unreadable digits and letters.

Does anyone know why this is happening? Could it be a firmware difference between the Raid board and the JBOD board?

ANy help would be appreciated

Cheers

[594 byte] By [sunteam] at [2007-11-25 23:02:57]