StorEdge 3511 firmware upgrade
Hello!
I'm upgrading firmware on StorEdge 3511. I have 1 base module and 1 expansion unit. Firmware on the base module was upgraded earlier and now i want to upgrade firmware on expansion unit to the same version as on base module. All went fine untill upgrade of PLD firmware. Although all procedure was corresponding to README file and to messages on screen, firmware has not been upgraded correctly for any reason. Now "show ses-devices"
shows:
sccli> show ses-devices
Ch Id Chassis Vendor/Product IDRev PLD WWNN WWPN
-
2 12 0090C6 SUN StorEdge 3511F A0420 1100 204000C0FF0090C6 214000C0FF0090C6
Topology: loop(a)
2 28 092423 SUN StorEdge 3511F D0420 1000 205000C0FF092423 215000C0FF092423
Topology: loop(a)
3 12 0090C6 SUN StorEdge 3511F D0420 1100 204000C0FF0090C6 224000C0FF0090C6
Topology: loop(b)
3 28 092423 SUN StorEdge 3511F D0420 1100* 205000C0FF092423 225000C0FF092423
Topology: loop(b)
* indicates SES or PLD firmware mismatch.
and when i'm trying to issue "download pld-firmware sata1100.s3r" it says:
sccli> download pld-firmware sata1100.s3r
WARNING: The array will have to be power-cycled at the end of this procedure.
Power-cycling the array at the wrong time will cause permanent failure.
You will be prompted to power cycle the array at the appropriate time.
WARNING: The array will be offline for up to several minutes.
Are you sure? y
sccli: no SES device found
sccli: download enclosure firmware: error: firmware download not performed
sccli>
Will appreciate any help on this.
