Netra T1
When I switch on my NETRA T1 on LOM terminal appears continuously the
following message
**********************************************
PSTATE=0000000000000414 TBA=00000000f0f00000DCU
Control=000000000000000f
AFSR=0000000000000000AFAR=ffffffff8dac7400PIL=000000000000000d
I-SFSR=0000000000000000 D-SFSR=0000000000000000 D-SFAR=00000105a55252cf
TL=0001 TT=0068 TPC=00000000f0f1251cTNPC=00000000f0f12520
**********************************************
Any idea:
Thank you.
Ciao Claudio
[573 byte] By [
muzio] at [2007-11-25 22:50:04]
# 2
With only five lines of available output, it appears that your cpu is failing.
For most of the small Netra T1 models ...
T1-100, T1-105, X1, V100, V120, AC200, DC200
... you will need a service contract to get it repaired.
To generalize:
That cpu is part of the systemboard, not a removable piece.
The systemboard and/or even the entire system gets swapped out, and you migrate your RAM and disks to the new chassis.
If no service contract, it's much too expensive to repair.
It will cost less to throw the computer away and buy a new one.
For a definite analysis, you could contact Sun and open a service case.
# 3
If you have any spare Netra memory around it is fairly easy to swap, just make sure that you use ESD protection.And as myself and rukat said, you need to raise a call with Sun.
